• Depending on the situation, perform a combination of the solutions below.

• Print in the image improvement [MEDIUM] or [HIGH].

• Print the media advance adjustment pattern and adjust the media advance value.

• Raise or lower the heater temperature.
(Set the temperature of the front heater, print heater, and rear heater to be within the range of ±5ºC of 45ºC, 40ºC and 45ºC, respectively. Be careful not to lose the temperature balance.)

• Print in the print mode [QUALITY].
Set the print mode by the RIP software.
In the RIP software setting, choose the mode to increase paths (“High Quality”, “PASS”, “Quality”, etc.) and then print.*

• Print in the print direction [UNIDIR].
Set the print direction by the RIP software.
In the RIP software setting, choose the mode for unidirectional print ("Unidirectional", "Outward", etc.) and then print. *

• Print in the print mode [DENSITY].
Set the print mode by the RIP software.
In the RIP software setting, choose the mode to increase the ink amount ("Double", etc.) and then print.*

*To change the settings, contact the RIP software sales agency.

• Print using the known good media that has been used in the past.